4
Assembly
CAUTION
m
m
Inspect wiring, which, if damaged during shipping,
may cause serious bodily injury during equipment
use. If any damage is seen or suspected, do not
assemble. Instead, contact Snow Joe Customer Service
for assistance.
Handle with care during assembly so that electrical
wiring does not become damaged.
Getting Started
1. Remove the snow thrower and all other items from the box.
2. Determine the left and right hand sides of the snow thrower
by standing in the normal operating position.
3. Check all items for shipping damage. If damage is seen or
suspected or if any of the parts are missing, do not assemble.
Instead, promptly inform the dealer where you bought
the snow thrower or contact Snow Joe customer service
for assistance.
4. Check to make sure that the parts bag contains all of
the following:
Cable clips
(3 pcs)
Upper chute crank
(1 pc)
Two-sided open-end wrench
(1 pc)
Upper, Middle, and Lower Frame
Assembly
1. Loosen and remove the four sets of joint fixing T-bolts,
washers, and knobs to separate the upper frame from the
middle frame (Fig. 2).
Figure 2
A – Upper frame
B – Middle frame
C – Lower frame
2. Hold the middle frame so that the screw holes align with
the holes on the lower frame. Insert the joint fixing T-bolt
into the aligned holes on each side. Use the washers and
joint fixing knobs to secure the connection on both sides
(Figs. 3 – 5). The joint fixing T-bolts should be inserted inside
the frame of the unit so that the washers and joint fixing
knobs are fastened to the outside of the frame.
Note:
1. Make sure the middle frame is held upright, following
the UP mark attached to the middle frame. Holding
the middle frame in the reverse direction will not
assemble the frames properly.
2. Do not overtighten the joint fixing knobs.
SJ622U1_MANUAL_ENG REV_Document 1 9/2/10 2:32 PM Page 4
