SNOWDOG COMPACT B10ZE WL, Руководство пользователя

Страница: 5 / 16

5
8 SNOWDOG set-up
8.1 Installation of the case support bracket
Prior to startup of Snowdog install the case support bracket,
which is supplied with Snowdog. You will need a Philips
screwdriver for that. (not included).
Unscrew the cover fixing screw in the top part of the chassis.
Insert the bracket under the cover, aligning the screw holes
with the holes in the chassis. If necessary, bracket may be
slightly bended to align the holes.
Screw the bolts, previously unscrewed from the chassis, so
that the bracket would be places between chassis and the
cover, and would separate hot muffler from the cover.
Then put fabric cover on the Snowdog. When you put on the
cover make sure that there is a distance between cover and
muffler of not less than 4 inches (100mm). If the distance is
less the 4 inches (100mm), bend the cover bracket.
!
WARNING
!
When operating Snowdog at an
ambient temperature of over
41 °F (+ 5 ° C), it is necessary to
remove the cover and operate the
macine without a cover
8.2 Battery installation
It is necessary to install and connect the battery before startup
of Snowdog. You will need a battery (supplied with Snowdog),
metric wrench (not included) and a Philips screwdriver (not
included).
Unscrew 2 bracket mounting bolts using metric wrench.
Install the battery, and tighten it with the bracket suign the
metric wrench.
Connect the electric wires to the battery, strictly observing
the polarity. Wire with the red cover is connected to the cleat
market with + sign, wire with black cover is connected to the
cleat marked with - sign. Tightly secure the contacts.
General view of the assembled battery.
!
WARNING!
Pay attention to the polarity when
connecting the battery!
!
WARNING!
Do not turn on the headlight when
the battery is not connected!
V
NOTE
The voltage of the charged battery
should be within the range of 12.6-
12.9 volts. If the battery voltage
is less than 12.6 volts, it must be
charged.
!
WARNING
!
Do not use chargers with voltages
above 14.6 volts. This charger will
damage the battery.