SNOWDOG COMPACT B10ZE WL, Руководство пользователя

Страница: 10 / 16

10
V
If your model is equipped with a
track support roller, its needs to
be temporarily removed before
measuring the tension.
17.4 Track tensioning
Loosen the screws 1 on both sides of the rear mounting shaft.
Turn eccentric 2 to adjust the tensioner axis.
V
NOTE:
V
To eliminate track distortion,
eccentric tensioner should be evenly
set with the right and left side of the
SNOWDOG.
Check the track tension. Tighten the
bolts.
17.4.1 Check the chain tension
It is necessary to remove the protection cover to check the track
tension or change the sprocket or chain. To do this, remove the
three screws 1 that hold the chain cover and remove the cover .
To install the cover do same steps in the reverse order.
Correctly tensioned chain will have a loose lift of 0.4-0.8 in (10-
20mm) between the sprocket. Loose lift less than 0,2 in (5mm)
will result in rapid chain stretching, and will lead to fast sprocket
wear. An excessively loose chain can fall off during operation.
Loose chain needs to be tightened . While operating, the chain
stretches, and the distance between chain links changes . If the
adjustment range is not enough, then the chain should be
replaced. Do not shorten the chain by removing one or more
links. When cleaning chain, check the condition of the rubber
seals between the plates. If the seals are damaged, and two tips
protrude from the chain, the chain requires urgent replacement.
17.4.2 Adjusting chain tension
To adjust the chain tension:
1. Loosen the screws
1
that mount motor and CVT brackets
with Snowdog chassis platform.
2. To loosen the chain you need to move the engine mount
with the motor forward in the direction of movement, to tension
the chain move the chain tensioning engine mount with the
motor back against the direction of Snowdog movement.
3. Check the chain tension. Repeat step 2 if necessary.
4. Tighten six bolts to the engine mounts of the Snowdog
chassis platform.