Snowbear 324-080, Инструкция по эксплуатации

Страница: 19 / 52

v.190702
En.19
ENG
L
IS
H
PLOW OPERATION WORKS OPPOSITE TO THE
DIRECTIONS ON THE CONTROLLER
button is pressed and vice versa)
Check that the red lead is connected to the positive (upper) terminal on the
winch, and the black lead connected to the negative (lower) winch terminal.
THE WIRING, CONTROL SWITCH OR CONTROL BOX ARE
HOT.
Be sure that a circuit breaker has been installed between the red battery cable
and the battery’s positive terminal. The breaker bracket must be connected
between the battery and the brass terminal on the circuit breaker.
MAINTENANCE
REMINDER The Detail K2 plow was designed for personal use ONLY and not
rated for commercial use.
Using it in commercial applications or travelling above the recommended speeds
will result in us voiding your warranty. It can also cause serious damage to the
plow, or to your vehicle as well as possible personal injury.
SnowBear® recommends the following general maintenance
information:
Continuous heavy operation may demand a more intensive service regimen.
Snow Plowing will subject any vehicle to very heavy demands. As a result,
thorough inspection and bringing both the Snow Plow and the vehicle up to the
best possible operating condition is extremely important.
Before the beginning the plowing season, and after each use, inspect both the
vehicle and Snow Plow.
Lubricate all moving parts with synthetic grease. Check all electrical
connections for corrosion or wear.
PRE-SEASON VEHICLE MAINTENANCE
Have all scheduled vehicle maintenance performed as recommended by the
manufacturer.
In
1. Windshield wipers, heaters, and lights are working correctly
2.
3. Your vehicle is equipped with chains when necessary.
4. The operator uses protective clothing and rubber gloves when handling
caustic snow-melting chemicals.
DK2 Universal Plow Manual v.210226
SnowBear® Plow Manual v.220623