SNOW WOLF UltraPlow, Руководство по эксплуатации и техническому обслуживанию

Страница: 32 / 76

30
UltraPlow Operation and Maintenance Manual
Cutting Edge Trip Spring
Adjustment / Replacement
Set trip springs after first use, then twice per
year thereafter.
Figure 2
Cutting edge trip springs (Item 1) [Figure 2] are
adjusted by loosening the jam nut (Item 2) located
on the rod between each spring, then tightening or
loosening the threaded bolt (Item 3).
Springs are adjusted correctly when there is a
.001” gap between the coils. Tighten jam nut.
NOTE: Use grease or “Anti Seize” on the rod
and jam nut to prevent rusting.
NOTE: Adjust trip springs evenly on both
sides.
Wear Shoe Adjustment /
Replacement (if equipped)
Place blocks under the UltraPlow (both sides) to
hold the wear shoe off the ground.
Remove the retaining pin, spacers and remove
the wear shoe.
Install or remove spacers for desired blade
clearance when installing wear shoe. Install
retaining pin.
Repeat procedures on the opposite side.
NOTE: Wear shoes must be set to the same
height.
Hydraulic Angle Cylinder
Figure 3
Periodically check the angle cylinder’s gland nuts
(Item 1)
[Figure 3] for tightness. Do not over
tighten.
1 1
2
3
1