Snorkel SL26RTE, Руководство пользователя

Страница: 144 / 209

Page 3 - 14 SL26/30SL
ADJUSTMENT
1. Disconnect the cylinder rod ends (if connected).
2. Operate steering so that both ends of the cylinder rod are equal in length therefore within 0.8
mm (1/32 inch).
3. Position both tyres so that they are parallel with the frame, with each other and with the rear
wheels.
4. Adjust rod ends until they align with the holes on the steering linkage bars.
5. Re-install the bolts through the steering linkage bars and rod ends. Tighten the jam nuts on
the rod ends and all hardware.
6. When properly adjusted, the wheels must turn the same amount in each direction. The steer-
ing stops must make contact with each side at the same time.
LIFT CYLINDER
NOTE: Do not support or raise the front of the platform during any maintenance operation
as this might result in damage to the tension members.
REMOVAL
1. Raise and chock the front of the elevating assembly approximately 300 mm (12 inches)
above the chassis support with a jack stand; a minimum rating of 2000 kg (4000 lbs.).
2. Open the emergency lowering valve to ensure all the pressure is released from the lift cylin-
der.
3.
Remove and cap both hoses and fittings.
4. Support the lift cylinder to prevent it from falling.
5. Remove the setscrew from the end of the cylinder rod.
6. Remove the retaining ring from the upper cylinder pin. Remove the upper cylinder pin by
tapping out using a soft punch.
7. Remove the retaining bolt from the lower cylinder pin and remove the pin using a soft punch.
8. Remove the cylinder by sliding it out towards the front of the machine.
15
1
2
3
4
5
6
7
8
9
10
11
12
13
14
16
17
10
Figure 3-9 : Steering Cylinder assembly
1 Cylinder barrel 2 Velocity fuse
3 Fitting, Adapter 4 Hose assembly
5 Breather 6 Piston nut
7 Piston seal 8 Piston
9 Piston static
O-ring
10 Static O-rings
11 Head cap 12 Cylinder rod
13 Set screw 14 Rod wiper
15 Rod seal 16 Nut
SERVICE AND REPAIR