Snorkel SL26RTE, Руководство пользователя

Страница: 30 / 209

Page 2 - 21 SL26/30SL
INSPECTION AND MAINTENANCE
DAILY PREVENTATIVE MAINTENANCE SCHEDULE
MAINTENANCE TABLE KEY PREVENTATIVE MAINTENANCE REPORT
Y = Yes/Acceptable Date: ______________________________
N = No/Not Acceptable Owner: _____________________________
R = Repaired/Acceptable Model #: ____________________________
Serial #: ____________________________
Serviced by : _________________________
Operator’s
Manual Check that the operators manual is in
the manual holder and all pages are
intact and readable
Labels &
Decals Check that labels and decals are in
place, intact and readable
Entire Unit Perform pre-operation inspection
Check for and repair any damage
Electrical
system Check cables and wiring harness condi-
tion (No wear or physical damage)
Battery
System Check electrolyte level
Check battery cable condition
Check terminals are clean and connec-
tors are tight
Check charger condition and operation
Charge batteries
Hydraulic
fluid
Check oil level
Hydraulic
system
Check all fittings are tight and there are
no leaks
Drive motors Check for operation and leaks
Hydraulic
pump
Check fittings are secure and there are
no leaks
Emergency
lowering Check emergency lowering correctly
(See emergency lowering procedure)
Controller Check condition and operation
Platform
deck and
rails Check fasteners are in place, correctly
tightened and not damaged
Check the structure and welds for dam-
age, deformation, corrosion and cracks
Check condition of deck (no damage,
deformation, corrosion or cracks
Check entry gate closure functions
correcly
Table 2 : Daily preventative maintenance check-
list
Elevating
assembly Inspect for external damage, dents, loose
rivets or cracks.
Check the structure and welds for dam-
age, deformation, corrosion and cracks
Chassis Check cables for pinch or rubbing points
Check the structure and welds for dam-
age, deformation, corrosion and cracks
Lift Cylinders Check for leaks
Wheels Check for loose components
Check for damage to tyres
Harness
anchor point Check fasteners are secure
Check for damage, deformation, corrosion
and cracks
System func-
tion inspec-
tion Conduct system function inspection (see
system function inspection procedure)
Emergency
stops Check that the emergency stop button on
the basket panels operates correctly
Check that the emergency stop button
on the ground control panel operates
correctly
Brakes Check that the brakes operate correctly
Horn Check that the horn sounds when acti-
vated
Controller
and Sensors Check that the level sensor functions cor-
rectly (drive and platform raise functions
are disabled and only platform lowering
enabled) when the platform inclination ex-
ceeds the specification inclination value.
Check full drive speed range is enabled
when the platform is stowed.
Check that only reduced drive speed
range is enabled when the platform is
elevated.
Engine Refer to your Kubota Operators Manual
for pre-operation checks
* NOTE: Use ISO #46 during summer
and ISO #32 during winter
COMPONENT INSPECTION OR SERVICES
Y N
R
COMPONENT INSPECTION OR SERVICES
Y N R
Table 2-2: Daily preventative maintenance
checklist