Snorkel S3010E, Руководство по запчастям и обслуживанию

Страница: 8 / 86

2-2 S3010E –514226-200
Warning
All personnel shall carefully read, understand and follow all safety rules and operating instructions
before operating or performing maintenance on any SNORKEL aerial work platform.
Electrocution
Hazard
Tip Over Hazard Collision Hazard Fall Hazard Trapping/Crushing
Hazard
THIS MACHINE IS
NOT INSULATED! NEVER elevate the
platform or drive the
machine while el-
evated unless the
machine is on a firm,
level surface.
NEVER position the
platform without first
checking for over-
head obstructions or
other hazards.
NEVER climb, stand,
or sit on platform
guardrails or midrail.
Beware of crushing
hazard when holding
handrails while the
platform is moving
in close proximity to
other objects.
USE OF THE AERIAL WORK PLATFORM : This aerial work platform is intended to lift persons and his tools as well as the
material used for the job. It is designed for repair and assembly jobs and assignments at overhead workplaces (ceilings,
cranes, roof structures, buildings etc.). Uses or alterations to the aerial work platform must be approved by
SNORKEL .
THIS AERIAL WORK PLATFORM IS NOT INSULATED! For this reason it is imperative to keep a safe distance from live
parts of electrical equipment! Do not get closer than the minimum distance recommended by National Regulation.
is prohibited! See “Platform Capacity” on page 18 for details.
The use and operation of the aerial work platform as a lifting tool or a crane is prohibited!
NEVER exceed the manual force allowed for this machine. See “Manual Force” on page 18 for details.
DISTRIBUTE all platform loads evenly on the platform.
NEVER fs, bumps, curbs,
or debris; and avoiding them.
OPERATE machine only on surfaces capable of supporting wheel loads.
NEVER operate the machine outdoors or indoors when wind speeds exceed 0 m/s (0 mph).
Do not operate the aerial platform in windy or gusty conditions. Do not add anything to or take anything into the aerial platform
that will increase the wind loading such as billboards, banners, flags, etc.
IN CASE OF EMERGENCY push EMERGENCY STOP switch to deactivate all powered functions.
IF ALARM SOUNDS
Climbing up the railing of the platform, standing on or stepping from the platform onto buildings, steel or prefab concrete
structures, etc.,
is prohibited!
Dismantling the entry gate or other railing components is prohibited! Always make certain that the entry gate is closed!
It is prohibited to keep the entry gate in an open position when the platform is raised!
To extend the height or the range by placing of ladders, scaffolds or similar devices on the platform is prohibited!
NEVER perform service on machine while platform is elevated without blocking elevating assembly.
INSPECT the machine thoroughly for cracked welds, loose or missing hardware, hydraulic leaks, loose wire connections, and
damaged cables or hoses before using.
VERIFY that all labels are in place and legible before using.
NEVER use a machine that is damaged, not functioning properly, or has damaged or missing labels.
To bypass any safety equipment is prohibited and presents a danger for the persons on the aerial work platform and in its
working range.
NEVER
are prohibited or permissible only at the approval by SNORKEL .
AFTER USE , secure the work platform from unauthorized use by turning the keyswitch off and removing key.
Certain inherent risks remain in the operation of this machine despite utilizing proper design practices and safeguarding.
Care must be taken to ensure that the machines meets the requirements of stability during use, transportation, assembly,
dismantling when out of service, testing, or foreseeable breakdowns.
In the event of an accident or breakdown see “Emergency Lowering” on page 12, do not operate the aerial platform if it is
platform back into service.
SAFETY RULES