Snorkel S3010E, Руководство по запчастям и обслуживанию

Страница: 32 / 86

Section 3 - Service & Repair Hydraulics
Page 3-9
3-7 H
YDRAULICS
H
YDRAULIC /
P
OWERPACK
O
IL
T
ANK
A
ND
F
ILTER
F
LUID
L
EVEL
Figure 3-5:
Hydraulic Power Pack and Filter
With Platform fully lowered, oil should be visible between
DO NOT fill above the Max line when the platform
is elevated.
O
IL AND
F
ILTER
R
EPLACEMENT
1. Operate the work platform for 10-15 minutes to
bring the hydraulic oil up to normal operating
temperature.
2. Open module drawer.
3. Disconnect the cables as indicated in Fig 3.5, take
care to note where to re-connect when re-fitting the
Power Pack.
4. Disconnect and plug the hydraulic hose from the
Power Pack Manifold Block.
5. Remove the two M10 Bolts from underneath the
Manifold Block and remove the Power Pack.
6. Drain the Tank and separate it from the Manifold
Block by removing the four fixing bolts.
7. Remove and clean the Suction Filter in cleaning
solvent and blow dry with filtered compressed air.
8. Re-assemble and re-fit the Power Pack as a reverse of
sections 3 to 6, replacing the ‘O’ ring seal between the
Tank and the Block.
9. Fill the hydraulic reservoir with hydraulic oil until the
oil comes up just past the Min line. Hydraulic tank has
a 7,2 liter ( 1.9 US gallon) capacity.
C A U T I O N
!
!
The hydraulic oil may be of sufficient temperature to cause burns. Wear safety gloves and safety
glasses when handling hot oil.
Max /Min lines on the Dipstick, if not, fill the tank.