4
Introduction
The information contained in this section will instruct you
on the proper installation and set up of the controller and
wire harness.
REMEMBER
After the SWS 30 is installed on the
vehicle, the Pre-Delivery Check List and Delivery
Check List must be completed.
Tool List
Installation
Figure 1-1
1. Locate the following parts:
• Vehicle Power Harness
• Battery Power Harness
• Toggle Switch
• Female Terminal (2)
• 3/8" Ring Terminal
• Cable Ties
• 20A Fuse
2. Disconnect the NEG. (-) battery cable from the
battery.
NOTE: Take the extra time needed to plan the routing of
the wiring harness before drilling any holes or fastening
the harness or toggle switch in place. Read all the
instructions carefully to ensure all the required conditions
are met for a safe and professional installation.
Figure 1-2
3. Uncoil the Battery Power Harness and attach it to the
Positive (+) terminal on the battery.
4. Look for an existing hole in the vehicle firewall. The
hole must be 3/8" or larger.
Safety Goggles
Wire Crimp Tool
Utility Knife
Drill
Drill Bit, 3/8"
20A Fuse
Toggle
Switch
Cable
Tie
Vehicle Power
Harness
Battery Power
Harness
Female
Terminal
3/8" Ring
Terminal
WARNING
Disconnect the vehicle NEG. (-) battery cable
while performing Steps 2 - 13
to avoid serious
bodily injury from electrical shock, fire, or
explosion. Do not re-connect battery cable until
indicated in step 14.
FAILURE TO FOLLOW CAN RESULT IN INJURY
OR DEATH.
BATTERY
FUSE
TOGGLE SWITCH
SWS 30
INSTALLATION
