3
SAFETY
BEFORE ATTEMPTING ANY PROCEDURE IN THIS
BOOK, READ AND UNDERSTAND ALL THE SAFETY
INFORMATION CONTAINED IN THIS SECTION. IN
ADDITION, ENSURE ALL INDIVIDUALS WORKING
WITH YOU ARE ALSO FAMILIAR WITH THESE
SAFETY PRECAUTIONS.
For your safety Warning and Information Decals have
been placed on this product to remind the operator
to take safety precautions. It is important that these
decals are in place and are legible before operation
begins. New decals can be obtained from Sno-Way or
your local dealer.
REMEMBER
The careful operator is the best
operator. Most accidents are caused by human error.
Certain precautions must be observed to prevent the
possibility of injury to operator or bystanders and/or
damage to equipment.
NEVER
exceed vehicle GVWR, GAWR or Vehicle Hitch
Tongue Weight Rating.
NEVER
operate spreader when under the influence of
alcohol, drugs or other medications that could hamper
your judgement and reactions. An accident may result in
serious injury or death to other persons or yourself.
ALWAYS
operate vehicle in a well-ventilated area. The
carbon monoxide in exhaust gas is highly toxic and can
cause serious injury or death.
NEVER
allow hands, hair or clothing to get near any
moving parts such as fan blades, belts and pulleys. Never
wear neckties or loose clothing when working on the
vehicle or Spreader.
NEVER
wear wrist watches, rings or other jewelry when
working on the vehicle or individual equipment. These
things can catch on moving parts or cause an electrical
short circuit that could result in serious personal injury.
ALWAYS
wear safety goggles when working on the
vehicle to protect your eyes from battery acid, gasoline,
and dust or dirt from flying off of moving engine parts.
ALWAYS
be aware of and avoid contact with hot
surfaces such as engine, radiator, and hoses.
ALWAYS
wear safety glasses with side shields when
striking metal against metal! In addition, it is
recommended that a softer (non-chipable) metal material
be used to cushion the blow. Failure to heed could result
in serious injury to the eye(s) or other parts of the body.
NEVER
allow children or unauthorized person to
operate this spreader.
NEVER
exceed 45 m.p.h. when loaded spreader is
attached to vehicle. Braking distances may be increased
and handling characteristics may be impaired at speeds
above 45 m.p.h. It is strongly recommended to load the
spreader at the job site and to dispense all of the
materials at the job site. Transportation of a loaded
spreader causes the material to become impacted and
may cause spreader flow problems.
ALWAYS
lock the vehicle when unattended to prevent
unauthorized operation.
ALWAYS
check the job site for terrain hazards,
obstructions and people.
ALWAYS
check surrounding area for hazardous
obstacles before operating this unit.
ALWAYS
inspect the unit periodically for defects. Parts
that are broken, missing or plainly worn must be replaced
immediately. The unit, or any part of it should not be
altered without prior written approval of the manufacturer.
ALWAYS
shut off the vehicle engine, place the
transmission in Park, turn the ignition switch to the “OFF”
position and firmly apply the parking brake of the vehicle
before attaching or detaching the spreader from the
vehicle or when making adjustments to the spreader
gates and/or deflectors.
ALWAYS
make sure personnel are clear of area being
spread. Material is discharged from spreader at a high
rate of speed and could injure bystanders.
ALWAYS
inspect bolts and pins whenever attaching or
detaching the spreader, and before traveling. Worn or
damaged components could result in the spreader
dropping to the pavement while driving, causing an
accident.
NEVER
place fingers in mounting frame or mount lug
holes to check alignment when attaching spreader.
Sudden motion of the spreader frame could severely
injure a finger.
NEVER
use material in the spreader containing twigs,
brush, plastics, cans or other trash. Foreign materials
could plug drive and discharge and damage unit.
NEVER
use wet materials in the spreader. This unit is
not designed to handle wet materials. Use only dry free
flowing materials.
NEVER
leave materials in hopper for long periods of
time. Remember salt is hygroscopic and will attract
enough atmospheric moisture to cause it to "cake".
NEVER
work on the vehicle without having a fully
serviced fire extinguisher available. A 5 lb or larger CO
2
or dry chemical unit specified for gasoline, chemical or
electrical fires, is recommended.
NEVER
smoke while working on the vehicle. Gasoline
and battery acid vapors are extremely flammable and
explosive.
NEVER
free up a jam or unclog spreader while it is
plugged in. Always turn off vehicle and unplug spreader
when working on it.
NEVER
remove a spreader full of material, or even
partially filled with material, from the vehicle. Always
empty spreader prior to removal from the vehicle.
REMEMBER
it is the owner’s responsibility for
communicating information on the safe use and
proper maintenance of this machine.
