-
21. Hazard lights Output (default=normal)
When set as Normal:
Connect the hazard lights output as normal using the Y-splitter lead.
If the Normal connection does not work then connect the hazard lights output to the hazard switch as shown below and set feature
#21 as Pulse or Continuous depending on the type of hazard switch
O
I
Control Unit
Sniper
X2
Hazard
Switch
Hazard Lights
Output
Hazard
Lights
When selecting Pulse or Continuous, try the factory default first (0.5sec). If the hazard lights do not flash as expected proceed to the
hazard light learning as follows:
-
Turn the ignition on and off 3 times (on-off-on-off-on-off).
-
The siren will chirp once to confirm the system is in learning mode.
-
Turn the vehicles hazard lights on and the hazard lights start to flash.
-
Within 10 sec. press and hold the valet switch.
-
The LED will turn on to confirm the valet switch is pressed.
-
Release the valet switch once the hazard lights have flashed 10 times.
-
The LED will turn off and siren will chirp once to confirm the learning is complete.
*
The system will leave the learning mode automatically if the valet switch is not pressed within 10 sec. or if the ignition is turned on.
