Snell IQOTX80, Руководство пользователя

Страница: 24 / 25

IQOTX80/81/82/83/84/99 www.snellgroup.com
System-RollTrack Screen
The RollTrack settings allow information to be sent, by means of the RollCall network, to other
compatible units on the same network.
Use the settings on the RollTrack screen to:
•
Enable or disable the RollTrack functions.
•
Configure up to 16 RollTrack outputs.
•
Specify the conditions that trigger RollTrack data transmission.
•
Set RollTrack destinations.
•
Specify the RollTrack commands to be sent.
RollTrack Sources
The RollTrack Source specifies the source of the information that triggers the transmission of data.
RollTrack Addresses
The full RollTrack Address comprises four sets of numbers. For example, 0000:10:01*99.
The first set, 0000 in the example, is the network segment code number.
The second set, 10 in the example, identifies the (enclosure/mainframe) unit.
The third set, 01 in the example, identifies the slot number in the unit.
The fourth set, 99 in the example, is a user-configured number that uniquely identifies the
destination unit in a multi-unit system. This ensures that only the correct unit responds to
commands. If left at 00, an incorrectly fitted unit may respond inappropriately.
RollTrack Commands
Each RollTrack command comprises two sets of numbers, for example, 33039:3. The first set,
33039 in the example, is the RollTrack command number, which identifies the command.
The second set, 3 in the example, is the value that is sent with the command.
Using RollTracks
To enable or disable RollTrack functions:
•
To disable RollTrack functions, select the Disable All check box.
•
To enable the RollTrack functions, clear the Disable All check box.
Issue 1 Rev 2 © 2012 Snell Limited Page 24