IQAES00/01/10/11
N33
IQAES00OPS 27/07/06
www.snellwilcox.com
Version 1 Issue 1
N33.16
Setup
Mode
These modules can be configured to provide up to
10 reclocked outputs for a single input or up to 5
outputs per input for 2 inputs.
1 Input
When checked all outputs will derive their input
signal from Input 1.
2 Inputs
When checked AES Outputs 1 will derive their
input signal from Input 1 and AES Outputs 2 will
derive their input signal from Input 2.
NonPCM Detect
The non-PCM detector may be set to respond to
the channel status bits as follows :
Test Audio bit
When checked and the Audio bit is found to be set
to non-audio it will be considered as non-PCM.
Test V bit
When checked and this bit is found to be set to 1
(non-valid) it will be considered as non-PCM.
Note that this is an OR function so if both items are
checked and one of the test bits are considered to
be non-PCM, the detector will report the signal as
being non-PCM.
If neither items are checked the detector will be
disabled.
This information will be reported to the logger
(nonPCM) if selected, and sent as a RollTrack
(Input non-PCM) if selected.
Information Window
This will display basic information about the status
of the unit.
Input 1:, Input 2:
This will show the status of the input. It can show:
LOST
The input signal has been lost
OK
The module is receiving a valid input
signal
Selecting this item sets all adjustment functions
that include a preset facility, to their preset values.
This will reboot the unit simulating a power-down
power-up cycle restoring power-up settings.
Software version
This item shows the version of the software fitted
in the module.
Serial Number
This item shows the serial number of the module
Build Number
This will indicate the factory build number. This
number defines all parameters of the unit (software
versions, build level etc.) for identification
purposes.
Information
Window
