www.snellgroup.com
Mach HD V2 Motion Compensated Standards Converter with Synchronizer, Up, Down, and Cross Conversion
Version 1 Issue 1
©
Snell 2009
Page 54
Audio A, Audio B, Audio C, and Audio D
The settings on these four tabs enable the audio
input sources to be specified for the Left and Right
channels. Since each tab differs only in the audio
pair that is controlled, it is described only once.
Audio in A/B/C/D Left
These specify the Left audio input source.
•
De-embed ch 1
-to-
De-embed ch 16
•
Analog A – Left
•
Analog A – Right
•
Analog B – Left
•
Analog B – Right
•
AES A – Left
•
AES A – Right
•
AES B – Left
•
AES B – Right
•
Tone
•
Silence
Audio in A/B/C/D Right
These specify the Right audio input source. The
options are the same as the Left input source.
Preset Values
The audio input channels have the following
default values:
•
Audio in A Left: De-embed ch 1
•
Audio in A Right: De-embed ch 2
•
Audio in B Left: De-embed ch 3
•
Audio in B Right: De-embed ch 4
•
Audio in C Left: De-embed ch 5
•
Audio in C Right: De-embed ch 6
•
Audio in D Left: De-embed ch 7
•
Audio in D Right: De-embed ch 8
Pair Routing A/B/C/D
Select this option to configure the Left and Right
as a pair.
With Pair Routing enabled and after selecting a
source for Audio in A – Left, the unit will
automatically route the corresponding stereo
channel to Audio in A – Right. E.g. If De-embed ch
8 is selected for Audio in A – Left the unit will
automatically route ch 9 to Audio in A – Right.
Pair A/B/C/D non PCM
Selecting this option allows the unit to pass,
unchanged, non-PCM data on a left/right channel
pair.
Note Genlock settings on page 44.
Gain pair A/B/C/D
Use the slider to apply a gain to the audio pair of
±18dB in 0.1dB steps.
Click reset to return the control to its preset value
of 0dB.
