7
OPENING AND CLOSING
OPENING:
1. Enter the 6-digit combination code.
2. Rotate 3-spoke handle clockwise into the open position and pull door open.
3. The Entry Keypad relocks in 4 seconds after a valid code has been entered.
4. The Entry Keypad will return to “standby” status with a long beep sound if
there is no operation in 10 seconds after the system has been activated.
5. If you enter an incorrect combination 4-times in a row, the lock will shut
down for 5-minutes.
ELECTRONIC LOCK OPERATING INSTRUCTIONS
The SafeLogic Xtreme comes with the user code set to the factory default of
1-2-3-4-5-6.
TO OPEN THE LOCK WITH A CODE
1. Press 1-2-3-4-5-6.
2. The lock opens.
3. Then relocks after 6 seconds.
TO OPEN THE LOCK WITH A CODE
1. Enter 0-0-0-0-0-0
2. The lock will beep twice indicating that it is ready for programming
3. Enter the existing 6 digit code. The Lock will beep once.
4. Now enter the new 6 digit code. The lock will beep once.
5. Now repeat the new 6 digit code. The lock will beep once indicating that
the change code process is complete. If 3 beeps sound the code has not
been accepted. Repeat the process.
6. Now enter the new code to test the lock.
If the lock does not open using the new code, repeat the change code
process again.
MECHANICAL LOCK OPERATING INSTRUCTIONS
The mechanical combination of SafeLogic Xtreme preset to 50-50-50.
FIRST SPINDIAL COMBINATION OPENING
1. Pull up on the SpinDial Release to disengage
the electronics.
2. Now rotate the SpinDial 4 full revolutions to
the left (or counter clockwise) stop when you
see 50 at the Dialing Index the fourth time.
(The Dialing Index is the small red arrow
pointing to the numbers in the center of the
SpinDial Release as shown below).
