Snapper EYZ15334BVE, Инструкции по безопасности и руководство оператора

Страница: 20 / 31

20
Section 4 - ADJUSTMENTS & REPAIR
WARNING
DO NOT attempt any adjustments, maintenance,
service or repairs with the engine running. Stop engine.
Stop blade. Engage parking brake. Remove key.
Remove spark plug wire from spark plug and secure
away from plug. Engine and components are HOT.
Avoid serious burns; allow all parts to cool before
working on machine. Fuel Filler Cap and Vent must be
closed securely to prevent fuel spillage.
4.3.9. MOWER DECK TIMING ROD
The mower deck timing rod is pre-adjusted at the
factory. It is set to maintain the deck in the same
attitude through all heights of cut. If the timing rod
requires adjustment, contact an authorized SNAPPER
dealer for service.
4.3.10. WHEEL BRAKE ADJUSTMENT
Adjust the wheel brake if wheels turn when parking
brake is engaged. Adjust the wheel brake by turning
wheel brake adjusting nut clockwise to increase
braking action or counter clockwise to decrease
braking action. See Figure 4.11.
FIGURE 4.11
4.4 MOWER BLADE REPLACEMENT
4.4.1. BLADE WEAR LIMITS
1. Inspect blade frequently for signs of excessive wear
or damage. See Figure 4.12.
4.4.2. BLADE
SHARPENING
1. Make sure fuel cap is on tight. Turn fuel shut off
valve (If equipped) to the “CLOSED” position. Start
engine and allow it to run until engine runs out of
fuel. Close vent on fuel filler cap. Refer Figure 2.3.
2. Remove key from ignition switch.
3. Remove spark plug wire(s) and secure away from
spark plug(s).
4. Carefully stand YARD CRUISER on rear bumper.
5. Remove blade(s). See Figure 4.14.
6. Inspect condition of blade. See Figure 4.12.
7. Check blade balance after sharpening. If
necessary, correct blade balance by grinding the heavy
end of blade.
FIGURE 4.12
8. If blade is in good condition, sharpen at 22 to 28
degrees. DO NOT sharpen beyond existing cutting
edge. See Figure 4.13.
FIGURE 4.13
9. Reinstall blade. See Figure 4.14. Torque blade
mounting bolts to recommended range of:
33” Deck - 30 to 40 ft. lbs.
FIGURE 4.14
UNDERSIDE VIEW OF MACHINE
ADJUST
COUNTER-
CLOCKWISE TO
DECREASE
BRAKE
ADJUST
CLOCKWISE
TO INCREASE
BRAKE
WHEEL BRAKE
ROD
ELECTRIC
CLUTCH
NEW BLADE
WEAR LIMIT
(NOTCH STARTS)
DANGEROUS CONDITION!
DO NOT USE ON MOWER!
REPLACE WITH NEW BLADE.
DO NOT SHARPEN
BEYOND ORIGINAL
CUTTING EDGE
BLADE TIP
ORIGINAL CUTTING EDGE
22º TO 28º
REINSTALL MOUNTING
BOLTS TO SECURE
BLADE