!
12. How to install car seat for Group II, III (15-36kg,
approx. 4 to 7 years)
13. How to re-fit the car seat backrest
13
14
Important: Do not use any load bearing contact points other than those described in
the instructions and marked on the child restraint.
click
Step 1: Remove the 5-point harness system
and inner cushion. Hold onto the car seat
base and push the backrest down.
Step 2: Detach the backrest from
the car seat base.
Step 3: Place the booster seat in the
forward facing position on the vehicle seat.
Step 4: Place your child on the
booster seat.
Step 5: Pass the vehicle lap belt through the lap belt route slot
under the armrest.
Step 6: Place the vehicle seat belt over your
child. It should go through the lap belt route
slot under the armrest on the other side of
the car seat. Make sure the vehicle lap is worn
as low as possible, over your child’s hips.
Step 7: Fasten the seat belt into
the buckle properly until you hear
a “click” sound. Tighten the seat
belt and remove any slack.
To re-fit the car seat backrest, attach the backrest to the car seat base as shown.
Engage the two pegs and press down firmly on the backrest so that the two pegs
engage securely. Lift the backrest upwards. Make sure the backrest is secured.
1
2
3
4
