63
Scan Module Operation
Troubleshooting
5.5.1 No Communication Message
If the Scan Module is paired to the diagnostic tool and tries to communicate with the vehicle and
the Scan Module is not connected to the vehicle, a “Connect Data Cable” or “no communication”
message displays.
A signal lost due to moving out of range automatically restores itself when the diagnostic tool is
brought closer to the Scan Module. The Scanner sounds a tone when the signal is lost.
The following conditions cause a “no communication” message to display:
•
The Scanner is unable to establish a communication link with the vehicle.
•
You selected a system for testing that the vehicle is not equipped with (such as ABS).
•
There is a loose connection.
•
There is a blown vehicle fuse.
•
There is a wiring fault on the vehicle, or in the data cable or adapter.
•
There is a circuit fault in the data cable, Personality Key, or adapter.
•
Incorrect vehicle identification was entered.
Refer to the Vehicle Communication Software manuals for manufacturer-specific troubleshooting
information.
5.5.2 Signal Loss / Out of Range Alarm
A signal lost due to moving the diagnostic tool out of range of the Scan Module will automatically
restore itself when the diagnostic tool is brought closer to the Scan Module. The Scan Module will
sound an audible tone when the signal is lost.
