16
How to Setup the Optional Variable Amperage Foot Pedal or
Remote Finger Amp Control (RAD).
•
Using High Frequency Start
•
TIG AC Mode
The Foot Pedal allows the welder to remotely control the
amperage from 5 amps minimum to 150 amps maximum
shown on the LED
Z
display.
Install the Foot Pedal or RAD control plug in the
AE
receptacle.
Push the procedure selector switch (Left Hand Down
Arrow). This push-button selects the welding procedure
(MMA or TIG). When selected, one of the following LEDs
lights:
B
,
C
, or
D
Then push the Mode Key
E
(Right Hand Down Arrow).
When selected, one of the following LEDs lights:
F,G,H,L,M,N. Continue to push the button until the
L
LED
lights along with the
G
LED.
L
- LED. TIG welding with arc started with
high frequency.
---NOT AVAILABLE IN THE MMA MODE
G
LED. Continuous 2-stage TIG welding
(manual).
Push the
P
– Selector (Right Arrow) until the
T
–
LED main welding current display lights.
(10-130A in MMA and 5-150A in TIG)
Activate the foot pedal or RAD to the maximum (pedal or
slider fully depressed) position.
While holding down the pedal to maximum,
turn the
AA
knob while watching the
Z
display.
Z
DISPLAY
Adjust the amperage to the approximate current that is
required using the basic rule of thumb “one amp per
thousandths of material thickness. Ex. 1/8” inch = .125
thousands so set the amps to ~125.
Push down on the pedal or slide the RAD.
The gas should purge.
High frequency should activate.
Amperage on the display
Z
should range from
5 to 125 amps.
NOW BEGIN TO WELD.
OPTIONAL FOOT PEDAL/
REMOTE AMPERAGE CONTROL
Push the button until the TIG
AC
LED lights
.
