Snap-On EELR 343A, Инструкция по установке и эксплуатации

Страница: 17 / 29

16
5.12 HYDRAULIC ADJUSTMENT PROCEDURE
Important! Should your lift come out of synchronization, i.e. one carriage is higher than
the other, it is necessary to level the lift hydraulically.
When
slave side is higher than the power side:
1.
Lower lift on to the first safety on the power side.
2.
Open by-pass valve. Push the down control lever. This will cause the slave side
carriage to be lowered. Stop lowering when the slave side carriage stops on the first
safety.
When
power side is higher than the slave side:
1.
Open the by-pass valve, raise lift until the slave side carriage is approximately 1-2”
higher than the power side carriage. Stop raising and close by-pass valve.
2.
Lower lift by pushing the down control lever. Stop lowering when the power side
carriage touches the first safety.
3.
Next, open the by-pass valve. Push the down control lever so that the slave side
carriage lowers. Stop lowering when the slave side carriage touches the first safety.
Close the by-pass valve.
5.13 TOWER POSITIONING AND ANCHORING
WARNING! Failure to follow these instructions may cause an unsafe operating
condition .
WARNING! Before proceeding with installation, review Section 4: Installation
Requirements & Tools.
1. Using a 4ft. level on top of the crossmember, determine which column is higher
(Figure 13).
2.
Using 2 ft. level on the sides of the high column, ensure that the column is level in
the vertical position
(Figure 14) . Use shims under the column baseplate to hold
the column level. Ensure that the base plate is completely supported by shims
where it does not contact the floor
(Figure 15) .
WARNING! Do not use more than ½” (13mm) of shims. Anchor bolts supplied
allow for a maximum of ½” (13mm) of shim. If more than ½” (13mm)
of shims are required, DO NOT proceed with installation and contact
Product Manufacturer / Supplier for further details.