10
Operating Instructions
NOTE: Your grill is designed to operate with a 16.4 oz. (DOT 39 cylinder).
1. Check that the regulator control valve is off.
2. Hand tighten propane cylinder to regulator control valve.
3. Attach regulator to grill. Hand tighten securely.
The installation of this appliance must be in accordance with all applicable local codes, or in the absence of local codes,
either: National Fuel Gas Code ANSI Z223.1 NFPA 54 or Natural Gas and Propane Installation Code: CAN/CGA B149.1. To
check your local codes, see your local LP gas dealer or Natural Gas Company. This grill was not intended to be connected to
a natural gas supply line. If an external electrical source is utilized, it must be electrically grounded in accordance with local
codes, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code,
CSA 22.1. The LP-gas supply cylinder to be used must be constructed and marked in accordance with the specifications
for LP-gas cylinders, U.S. Department of Transportation (DOT) or the Standard for Cylinders, Spheres and Tubes for the
Transportation of Dangerous Goods, CAN/CSA-B339.
• Gas leak testing must be performed outdoors
in a well-ventilated area every time cylinder is
connected to regulator and grill.
• Always keep unit away from open flames or sparks.
• Never use a flame to check for gas leaks.
• The regulator control knob is used when lighting
the burner and to adjust the flame.
• Never use a unit that has a gas leak. Contact our
Customer Service Department for replacement
parts or repairs Toll Free: 866-475-5180
Website: www.olp-inc.com.
• Propane cylinder should be positioned for vapor
withdrawal as shown below.
Step 1: Assemble grill per “Assembly Instructions” of this manual. Make sure regulator control knob is in
“OFF” position. Attach the propane cylinder to the regulator.
Step 2: Prepare soapy water solution (one part dishwashing liquid to three parts water) to test for gas
leaks at the connections. Apply a generous amount of soapy mixture to the regulator assembly at the
propane cylinder located on the right side of grill as shown.
Step 3: With the regulator control knob in the “OFF” position, check for bubbles where propane cylinder
attaches to regulator assembly. If soapy mixture starts bubbling, gas is leaking through the connections.
Disconnect the propane cylinder. Re-tighten the connection that is leaking gas. Repeat procedure with
soapy mixture until gas no longer leaks.
NEVER USE A FLAME TO CHECK FOR GAS LEAKS.
Step 4: Once all gas leaks have been sealed;
WAIT AT LEAST 5 MINUTES FOR GAS FUMES TO DISPERSE BEFORE LIGHTING THE BURNERS.
Carefully follow “Operating Instructions” to light the burner and properly operate this unit.
INSTALLING THE LP GAS CYLINDER ONTO THE GRILL:
GAS LEAK TESTING:
11
See steps on microsoft word.
INSTALLING THE LP GAS CYLINDER ONTO THE GRILL:
LIGHTING THE GRILL:
YELLOW
BLUE
Burner
Good Flame
Bad Flame
OFF
HIGH
Operating Instructions
See steps on microsoft word.
Regulator
Control
Valve
Propane
Cylinder
Apply soap solution
here and watch for
bubbling. If bubbling
occurs, try adjusting
connection.
