Gas Cylinder Safety Information
•
This appliance is designed to be used with a gas cylinder not exceeding (Australia 9KG)
•
The gas cylinder supply valve must be turned off when the appliance is not in use.
•
Gas cylinders must be stored outdoors, out of reach of children and must not be stored in a building, garage or
any other enclosed area.
•
The gas cylinder used must incorporate a safety collar to protect the valve assembly.
Important:
•
When disconnecting and removing the gas cylinder for the purpose of refilling, always observe the following
procedure.
•
Ensure the gas control valve on the appliance and the gas cylinder are turned off before disconnecting the
regulator from the cylinder.
•
Do not smoke or use a naked flame near the appliance or gas cylinder while disconnecting the gas line between
the appliance and gas cylinder.
•
Remove the gas cylinder from the enclosure before disconnecting the regulator from the appliance.
•
Tighten all connections before placing the gas cylinder back in its enclosure.
•
The gas leak testing procedure should be conducted every time the gas cylinder is refilled and reconnected to the
appliance before using the appliance.
Regulator Connection
1. Check the control knob is
in the ‘Off’ position.
2. Make sure the cylinder valve is off.
3. Remove the protective cap from the cylinder if present.
4. Leak test the connection with a soapy water solution.
Gas Leak Test Procedure
Never use a naked flame to check for gas leaks. Always use the following procedure to check for gas leaks.
1. In a small container, mix up a solution of water and detergent or soap. Mix the solution well.
2. Make sure that the gas supply valve on the gas cylinder is turned on.
3. Make sure that the gas control valves on the appliance are all turned off.
4. Using a brush or spray bottle apply the solution to the gas line and each join in the gas line.
5. Bubbling of the solution will indicate that there is a leak present.
6. Re-tighten or re-seal any joints that are leaking.
7. If a leak persists then contact your distributor or the manufacturer for assistance.
