Smithco 45-001C, Руководство оператора

Страница: 12 / 30

10
Introduction
PARTS MANUALS AVAILABLE ONLINE AT smithco.com
CONTROLS & INSTRUMENTS DIESEL MODEL
INSTRUMENTS LOCATED ON THE CONTROL PANEL
A. Hour Meter - The hour meter indicates hours
of machine operation. It operates only when the
ignition switch is on.
B . Glow Plug: When ignition is turned to preheat,
glow plug lights when ready to start.
C . Temperature Light: The temperature light will
come on if machine starts to over heat.
D. Oil Light - The oil light should come on when
ignition is on without engine operating. The oil
light will light when the oil pressure is low. If oil
light should come on, shut off engine immedi -
ately and find the cause.
E. Ignition Switch - The ignition switch has three
positions: Off-Run-Start.
F.
Hand Throttle
- The hand throttle is used to
regulate engine speed.
G.
Light
- (OPTIONAL) This is a Rocker switch to
turn on and off lights
STEERING
Acquaint yourself with the steering before operating the machine. This ma-
chine is equipped with a tilt steering mechanism. The lever to tilt the steer-
ing wheel is located at bottom of rubber boot on steering column. Hold the
lever down and adjust the steering wheel to a comfortable position.
RAKE LIFT LEVER
Located on right fender, this outside lever (H) raises and lowers all rear
attachments. To raise push forward, to lower pull back. Release the lever
when attachment is in proper position and lever will return to neutral.
LIFT ASSEMBLY LEVER
Located on right fender, this inside lever (J) raises and lowers all attach-
ments under the center of the machine. To raise push forward, to lower pull
back. Release the lever when attachment is in proper position and lever
will return to neutral.
FRONT HYDRAULIC PLOW (OPTIONAL COMES WITH PLOW)
Located on right fender, this lever raises and lowers the hydraulic plow in
front of machine. To lower push forward, to raise pull back. Release the lever
when attachment is in proper position and lever will return to neutral.
RIGHT FLOORBOARD
Foot Pedal controls forward and reverse motion. Pushing down on the inside
pedal (L) will give you a forward motion and pushing down on outside pedal
(M) will give you a reverse motion. When pedal is released the hydrostatic
transmission centers and stops the vehicle. Ground speed is proportional to
how far the foot pedal is depressed.
SEAT ADJUSTMENT
Seat adjustment lever is located under front of seat on left side. It allows seat adjustment forward or backward
for operator's comfort. The seat also has the start safety switch in it. To start the Sand Star the operator must
be sitting on the seat.