POSYC 4301/4302/4303 series industrial PCs
Installation, use and maintenance manual - EN
Rev. 1.02
25
7.2 Assembly in dedicated body
The POSYC can be mounted in one of the two dedicated aluminum frames (for the order codes see specific
chapter).
Both have a predisposition for the attachment to a support arm with standard dimensions and holes "VESA
MIS-D, 100, T". To fix the body to the arm, then use four M4x10mm steel screws (not supplied).
Prepare the POSYC by screwing the MA117784 spacers (supplied with the computer) into the four holes at the
corners of the frame. A 6mm spanner wrench is required for tightening.
Slip the POSYC to the body by sliding the spacers in the appropriate seats of the same and secure it by screw-
ing the two M5x60mm screws (MF300543 supplied together with the body) into the intermediate holes, tight-
ened to 3 Nm. To hold it tight, screw the four M5x10mm screws (MF300168 supplied together with the body)
into the holes in the corners, tightened to 3 Nm.
Then, to inspect the connections and the CFast without completely releasing the computer from the body, re-
move the four screws at the corners and take advantage of the sliding of the spacers.
