Smeg WDF147-2, Инструкция по эксплуатации

Страница: 10 / 31

EN
9
Warning!

This operation must be carried out with care to prevent the washer-dryer
from vibrating, moving or generating excessive noise during use.

If the appliance is installed on a carpeted floor, take care to ensure that the
openings in the bottom of the washer-dryer are not obstructed.

Also check that during operation the washer-dryer is not resting against walls,
kitchen units, etc.

The appliance must not be installed behind a door with lock, a sliding door, or a door
with hinge on the opposite side.
2.3 CONNECTING TO THE WATER SUPPLY
1. Check that the water supply pressure is in the following
range: 0,05-0,9MPa . With higher pressures, use a pressure
reducer.
2. Connect the cold water supply hose ( blue screw collar)
to the cold water tap with ¾ gas threaded connector, taking
care to tighten firmly to prevent leaks. The water supply
hose must not be kinked or crushed and must not be
changed or cut. Threaded connections must only be tight-
ened by hand.
3. When appliances are supplied with hot water , the intake water temperature must
not exceed 60°C and the hose with red screw collar must be connected to the hot
water supply tap.
Warning!

If the connection is made to new pipelines, or lines which have been out of use
for a long time, allow a considerable amount of water to flow out before connecting
the intake hose. This prevents any sand or other dirt from fouling the filters installed
in the appliance to protect the water intake valves.

The new intake hose supplied with the appliance must be used, and the old water
supply hose must not be used.
Supplementary note regarding the water connection for the German market.
Before connecting the product to the water supply, make sure that the water system has
been fitted with a safety device to protect drinking water against contamination due to back-
flow (according to DIN EN 1717). The water valves and/or taps are fitted with these safety
devices if the water system of the house has been properly implemented.
2.4 CONNECTING TO THE DRAIN
1. Insert the end of the drain hose into a drain pipe having inside diameter of at least
4 cm, at least 50 to 90 cm above floor level, or connect it securely (using the plastic
fitting on the elbow in the hose) to a sink or bathtub.