19
When the display control panel is switched on, the
display shows the type of dishwasher (PRF 400,
PRF 500, CAPOTE…….), followed by the firmware
version and update installed.
If the dishwasher is already powered up, press the
on/off button for direct display of the firmware
version and update installed.
7.1
SET-UP (
Authorised staff only
)
Dishwasher parameter modification procedure
With the tank empty
1- Switch the appliance on; the display will show
“FILL” and filling will start.
2- Open the door/lift the hood (depending on the
model); "CLOSE" will appear on the display
3- Press the
button and hold it down for 5/7
seconds. When -------- appears on the display, release
the button and press it again to access the main PCB
setup menu.
With the tank full/the hood open
1 - Press the
button and hold it down for 5/7
seconds. When -------- appears on the display, release
the
button and press it again to access the main
PCB setup menu.
All the modifiable parameters can now be displayed, scrolling through them with the
button.
Press the
button to select the value required for each parameter.
To confirm the value required simply quit the menu or move on to the next parameter by pressing
.
Quitting the setup menu automatically: wait about 3 minutes without using the controls.
Quitting the setup menu in manual mode: hold the ON/OFF button until the beep sounds; the
dishwasher switches off.
Set-up
During first start-up, the functions/parameters listed below must be set or adjusted:
Содержание UD515D
Страница 14: ...14 ...
