Smeg UD515D, Перевод оригинальной инструкции

Страница: 38 / 39

38
Improper set cycle
Increase the duration of the washing
cycle, especially if the load is very
dirty or partially dried.
Clogged nozzles
Boiler incrusted with
limescale
- Verify that the nozzles are clean and
that the water softener, if present, is
working correctly.
- Verify that the filter of the tube
placed inside the rinse aid jerrycan is
not clogged.
INSUFFICIENT RINSE
Inappropriate rinse aid, or it
is not dispensed correctly.
Low rinsing temperature
Verify the rinse aid container and if it
is adequate to the type of mains
water.
Verify the boiler set temperature
Restore T Stop ON and/or connect
the machine to hot water.
If the problem is not solved, contact
the After-Sales Service.
INSUFFICIENT DRYING
Inappropriate rinse aid, or it
is not dispensed correctly.
Water hardness superior
than 12°dF or it contains
many dissolved salts.
Verify the rinse aid container and if it
is adequate to the type of mains
water. If the problem is not solved,
contact the After-Sales Service
STAINED GLASSES AND
CUTLERY
Rinse aid unsuitable or not
being delivered correctly.
Water hardness above 12°dF
or large amounts of dissolved
salts
Check container of rinse aid and
whether type is suitable for the
mains water- If the problem persists,
contact the after-sales service.
WATER LEFT IN THE TANK
AFTER PUMP-OUT. Waste tube badly positioned
or partially clogged.
Verify that the tube and drainage are
not clogged and that the drainage is
not positioned too high; see
connection scheme.
THE DISHWASHER DOES NOT
TURN ON, “OFF” APPEARS
ON THE DISPLAY and THE
SALT LIGHT FLASHES.
The salt lock has activated
due to the lack of
regeneration salt.
Top up the regeneration salt.
THE CHAMBER AND BOILER
HEATING ELEMENT LIGHTS
FLASH AT THE SAME TIME. CONFIGURATION FAULT
THAT PREVENTS THE WATER
FROM HEATING.
CONTACT THE AFTER SALES SERVICE