36
ALARM ID
DESCRIPTION
USER ACTION
A:67
Dryer motor cooling cycle fault.
This cycle runs after drying to
bring the dry load and heating
elements to a safe temperature.
Only for model SWT260X
User: run the DEFAULT PROCEDURE described above. If the
alarm does not reset, run the RESET PROCEDURE.
AF:74
Aquastop device tripped (where
applicable).
User: run the DEFAULT PROCEDURE described above. If the
alarm does not reset, run the RESET PROCEDURE.
AF:78
Restore fail. Motherboard error.
User: run the DEFAULT PROCEDURE described above. If the
alarm does not reset, run the RESET PROCEDURE.
AF:84
Dryer temperature higher than
setpoint. Only for model
SWT260X
Wait for the automatic alarm handling procedure to
terminate.
A RESET cycle cannot be run while alarm AF:84 is being
handled by the system.
Do not disconnect power: automatic heating malfunction
management in progress with heating element cooling
cycle.
Only when this procedure has terminated can you run the
DEFAULT PROCEDURE described above.
AF:96
Wash chamber water level fault.
Check the water intake and drain fittings and that they meet
specifications.
If you notice any leaks around the appliance, close all water
taps.
User: run the DEFAULT PROCEDURE described above. If the
alarm does not reset, run the RESET PROCEDURE.
N.B.:
The drying system alarms (A 58, A 67) are displayed at the end of the cycle, and reset when the door is opened.
If the messages persist, contact your local authorised service centre.
