Smeg STH903, Инструкция по эксплуатации

Страница: 8 / 34

8
EN
2.1 Water supply connection
Preventing the risk of clogging or damage: the water pipe is new or has not
been used for a long time, before connecting to the water supply check that
the water is clear and free of impurities, to prevent damage to the appliance.
The dishwasher must always be connected to the water system with new
hoses; old or used hoses must never be reused.
CONNECTING TO THE WATER SUPPLY
Connect the intake hose to a cold water supply with ¾” gas
thread, inserting the fi lter
A supplied with the dishwasher.
Take care to screw the hose fi rmly into place with your
hands and then complete by tightening about 1/4 of a
turn with pliers.
In dishwashers equipped with the ACQUASTOP device,
the fi lters is already fi tted inside the threaded ring.
DRAIN CONNECTION
Fit the drain hose into a pipe having diameter of at least 4 cm ; the dishwasher
is fi tted with a special device which allows column installation, even with the
drain pipe below the level of the dishwasher.
2.2 Electrical connection and precautions
CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH
THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON THE
INNER EDGE OF THE DOOR.
THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET
OUTLET MUST BE OF THE SAME TYPE AND MEET THE REGULATIONS IN
FORCE.
THE PLUG MUST BE ACCESSIBLE AFTER INSTALLATION.
NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY
LEAD.
IN THE EVENT OF DAMAGE TO THE SUPPLY CORD
, HAVE IT REPLACED BY
THE MANUFACTURER OR AN AUTHORIZED TECHNICAL SERVICE CENTRE.
DO NOT USE ADAPTORS OR SHUNT CONNECTIONS IN ORDER TO AVOID THE
POSSIBILITY OF OVERHEATING OR BURNING.
Installation Instructions