Smeg STH903, Инструкция по эксплуатации

Страница: 28 / 34

User instructions
28
EN
GENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT
MAINTENANCE:
• The fi lters should be cleaned under running water using a stiff brush.
• It is essential to thoroughly clean the fi lters according to the above
instructions: the dishwasher cannot function if the fi lters are clogged.
• Carefully replace fi lters in their seats, to avoid damaging the wash
pump.
PROLONGED DISUSE:
• Run the soak program twice in succession.
• Unplug power cord from the socket.
• Leave the door slightly open , in order to prevent the formation of
unpleasant odours inside the washing tank.
• Fill the rinse aid dispenser .
• Shut off the water supply tap.
BEFORE STARTING THE DISHWASHER AFTER PROLONGED
DISUSE:
• Check that there are no deposits of sludge or rust inside the water pipe:
if there are, allow the water to run from the water supply tap for a few
minutes.
• Plug the power cord into the socket.
• Reconnect the water intake hose and open the tap again.
TROUBLESHOOTING MINOR PROBLEMS
In some cases it is possible to remedy minor problems by referring to the
following instructions:
If the program fails to start, check that:
• the dishwasher is connected to the electrical power supply;
• there is no power failure;
• the water tap is open;
• the dishwasher door is properly closed.
If water remains inside the dishwasher, check that:
• the drain hose is not kinked;
• the drain siphon is not obstructed;
• the dishwasher fi lters are not clogged.