Smeg RTU304GX, Руководство пользователя

Страница: 14 / 22

Installation
16
Do not bend or damage the flexible
connector when moving the appliance. The
pressure regulator has 3/8" female pipe
threads. You will need to determine the
fittings required, depending on the
dimension of your gas supply line, the
flexible metal connector and the shut-off
valve. The appliance should be installed in
rooms that have a permanent air supply in
accordance with the standards in force. The
room where the appliance is installed must
have enough air flow for the regular
combustion of gas and the necessary air
change in the room itself. The air vents,
protected by grilles, must be the right size to
comply with current regulations and
positioned so that no part of them is
obstructed, not even partially. The room
must be kept adequately ventilated in order
to eliminate the heat and humidity produced
by cooking: in particular, after prolonged
use, you are recommended to open a
window or to increase the speed of any
fans.
Gas connection
The appliance is shipped from the factory
for use with natural gas at a pressure of 5"
of the water column. When checking for
proper operation of the regulator, the inlet
pressure must be at least 1" greater than the
operating (manifold) pressure above.
When used with natural gas, the pressure
supplied to the regulator must be between
6" and 10,5" of the water column. To
convert the appliance to propane gas see
“Conversion to Propane Gas (LPG)”. A
qualified technician or installer must do the
conversion. The gas inlet to the unit is
located at the right rear of the appliance.
Install the pressure regulator (supplied with
unit) to gas inlet.
Position the gasket (supplied with unit) in
between the inlet and the regulator. Position
the regulator to have its cap easily
accessible. Turn the nut on gas inlet to hand
tighten plus 1/3 turn. Install the gas pipe to
the regulator using Teflon tape or pipe joint
compound (resistant to propane gas and
natural gas). Turn to hand tighten plus 1/3
turn. Do not exceed 1 turn for alignment, to
prevent possible damage to the gas
pressure regulator. Check inlet fittings and
regulator for leaks.
1 - Gas inlet (attached to the appliance)
2 - Gasket
3 - Pressure regulator
WARNING: Do not attempt any
adjustment of the pressure regulator, except
when converting to propane. Adjustments
could lead to leaks or cause incorrect gas
pressure to the appliance.