Smeg GW0160, Технические инструкции, Страница: 6 / 9

0160, 1160, 4060, 4190 Power Connection Conversion instruction Page 6 - 9
ILLUSTRATION PROCEDURE
5. On WD4190 and GW4190 you must remove the top of
the device, to access:
.to fuses
.to the mains switch (SZ)
placed in the right-hand side cabinet.
The top is fixed to the machine at the rear by means of
two screws, crosshead.
6. key to main components:
. fuse terminal clamps
. power supply terminal board
. voltage change terminal board “XCT” (configuration
shown is 400 V 3N~)
7. The first component to be replaced (or adapted by
cutting the unused wires) is the power cable.
(PAY ATTENTION: on WD4190 and GW4190 the power
cord is placed in the side cabinet).
If replacement is necessary, proceed as follows:
. Unscrew the fixing screws which secure the terminals at the
end of the cable and release the terminals;
. Connect the new power cable to the old one (still in place)
using adhesive tape;