Instructions for the user
39
Take care not to obstruct the combustion gas outlet flue in the back of the lid.
9.4 Lighting
To check that the burners inside the barbecue have ignited, hold one of your hands about 10 cm above
the racks: you should feel a gradually increasing amount of heat.
When lighting the radiant grill or rapid or auxiliary burners,
keep the knob pressed down for about 5
seconds to allow the thermocouple to heat up. The burner may go out when the knob is released: this
means that the thermocouple has not warmed up enough. Repeat the operation, keeping the knob
pressed down for longer.
If the burners have not ignited after several attempts, wait 5 minutes before attempting to light the
appliance again. This pause is necessary to allow any gas which has built up inside the appliance to
disperse. If no flame is obtained even after numerous attempts, contact your nearest authorised service
centre.
9.4.1
Electronic lighting of the burners
Next to each knob the corresponding burner is indicated ( See “The control panel” on page 35). To light
the flame, simply push down and turn the knob anti-clockwise to the minimum flame setting . To adjust
the flame, turn the knob to the zone between the maximum (
) and minimum ( ) settings. To turn off
the burner, turn the knob to the OFF position.
GAS OUTLET FLUE
GAS OUTLET FLUE
BQ ON TRO
LLEY
B
Q
FRE
E
-ST
ANDING
