www.smartwitness.com
37
Top Graph
The top graph shows the speed (red) and RPM (grey) and below are three
indicator bars that show driving patterns. The first bar shows driving (blue)
and idling (grey) and the second bar shows the speed.
White means that the vehicle was within both the permitted speed and eco-
speed limit, green means above eco-speed but within permitted speed limit,
and red means above the legal speed limit. The last bar shows the state of
the engine. White means the engine is off, blue means it is running properly
within the pre-set RPM limit, and red means over acceleration, i.e. exceeding
the pre-set RPM limit.
Bottom Graph
The lower graph shows the G-sensors. The x-axis is in red, y-axis in blue,
and z-axis is green.
The indicator bar on the previous page shows jolts in the G-sensor values,
i.e. G-sensor values that exceed the pre-set limit. The grey line means
normal conditions, red means jolts in the x-axis direction, blue in the y-axis
direction, and green in the z-axis direction.
Configurations for this function can be set by clicking the ‘Setting’ button in
the right bottom corner. This will bring up the pop up menu (shown below).
Here, you can set the limits for G-sensor, permitted speeding, excessive
RPM. Eco-speeding can be set under the ‘Analysis’ tab and ranges for the
two graphs can be set under the ‘Component’ tab.