SmartTrike Xtend Mg+, Руководство пользователя

Страница: 8 / 32

-8-
NOTE: This information is only available on the bicycle itself.
Each bicycle has a Recovery Code stamped into the frame. The Recovery Code
.can be found on the bottom of the crank housing as shown
Handlebar and Stem Installation
Adjusting the handlebar
WARNING: To prevent steering system damage and
possible loss of control, the “MIN-IN” (minimum
insertion) mark , on the stem must be below the top
of the locknut B .
NOTE:
Remove plastic cap C from the end of
the stem D .
A
WARNING: If the handlebar clamp in not tight enough, the handlebar can slip in the stem. This
can cause damage to the handlebar or stem, and can cause loss of control.
2
5mm 5mm
6mm
If necessary, loosen the handlebar clamp nut/screw F and rotate handlebar into
a comfortable riding position (
fig A, B).
NOTE: Do not over tighten. See torque
table for recommended torque.
fig B
fig A
D
E
C
A
B
STEPS:
1. Insert the stem D into the fork (
fig A).
2. Point the stem towards the the front section of
the bike.
3. Streamline the stem with the front fork and
tighten the stem bolt securely.
4. Tighten the stem bolt E just enough to hold it
in place.
1
F
3
F