Drive Startup Manual KEB-PM
Page 4
© 2019 Smartrise Engineering, Inc. All Rights Reserved
August 23,2019
Encoder
Heidenhain
Ziehl
Torin ECN413
Hollister Whitney
CLK-
Pink
Brown
Silver
Violet
DAT+
Violet
Violet
Purple
Gray
DAT-
Yellow
Black
White
Pink
SHIELD
Shield
Shield
Shield
Shield
Construction
All safety inputs are functional during Construction mode on the C4 product. When these safety
devices are installed, they are connected per
C4 Controller
sheet
02 Machine Room I/O
of the
prints, even if still on Construction mode. The following includes instructions for when none of
these devices have been installed prior to beginning on Construction mode.
Perform the following to wire the Construction Box. See
C4 Controller
sheet
01 Getting Started
for job specific information.
Connect a jumper from L120 to terminals LFT, LFM, and LFB. If rear doors are used,
connect LRT, LRM, and LRB.
Connect a jumper from H120 to PIT, BUF, BFL, and TFL.
If secondary brake is present, connect M120 to SFM.
Connect H120 through your machine room Run/Stop switch and connect it to SFH. A
closed switch indicates run; an open switch indicates stop. If no Run/Stop switch is being
used, connect H120 to SFH.
Connect your run bug. Wire the Up button to input CUP and the Down to input CDN.
Wire the Enable to CEN, jump high if not available. If no run bug is being used, leave the
inputs unwired.
Connect a jumper from 24VDC to MM.
Verify the Car Door Bypass and Hoistway Bypass switches are in the OFF position.
Place the Inspection switch to INSPECTION.
Содержание KEB-PM
Страница 1: ......
Страница 2: ...Page intentionally left blank...