pressure.
If the deck has a sloped edge, attach the two
square plastic pieces to the end of metal
bracket to make it level. Use the thicker
square piece for greater gradient slope. It
is important to make the bracket level so
that the alarm unit can be held vertically.
Clamp the unit onto this metal bracket by
the 2 sets of “U” shaped plastic clamps.
Tighten the screws, but do not strip the
threads.
Place the unit such that the wide side of the
moving sensor is parallel to the side of
swimming pool wall.
Check the sensor in the water. The sensor is
buoyant and should stay upright. If the
sensor lies on its side, please contact
your SMARTPOOL immediately. The
sensor must remain in an upright position
while it is in the water.
If you have to place the unit near the return, heavy water current may
set off the alarm. If this happen, put the sensor cap onto the sensor
cage as shown. Place the sensor cap against the water current.
Please note that sensor cage with a sensor cap will reduce the
sensitivity of the unit. Check the unit function according to that
described in the Sensitivity Adjust before use.
NOTE: The deflector will reduce sensitivity. Test
the alarm unit as described in Sensitivity
Adjust section before use
6
