5
Clip the Battery Hatch into place and tighten the screw. The Medi-Link GPRS/GSM is now
ready for use. Power the Medi-Link GPRS/GSM by connecting the AC power supply and
switching the Battery Switch to ON. At this stage the Medi-Link GPRS/GSM is attempting
to initiate communication with the GSM mobile towers which may take several seconds
before the Medi-Link GPRS/GSM has established a link. To ensure the Medi-Link
GPRS/GSM has the best GSM communication, use the
CELLULAR->Signal Quality->
’
feature and place the Medi-Link GPRS/GSM where signal quality is at it’s highest. The
remaining setup required is as per Medi-Link unit (standard).
6. Quick Setup Guide
1. Insert the SIM Card into the Medi-Link GPRS/GSM Unit (refer to Section 5).
2. Supply Power to the Medi-Link GPRS/GSM Unit by:
-
Connecting the AC Plug Pack to a Power outlet and connect the Plug to
“POWER” underside the Medi-Link GPRS/GSM Unit.
-
Sliding the Battery “ON/OFF” Switch to the “ON” position underside the
Medi-Link GPRS/GSM Unit.
3. While in Program Mode, enter the:
- 4 digits “Client Account” Code/Number
- Primary Phone Numbers for GSM (If required) “Ph.1 & 2 Primary”)
- Server 1 Primary Address and Port Number for GPRS (If Required)
4. After Exiting Program Mode, set the Time & Date by following the
instructions on Section 11. (Setting the Time & Date).
ATTENTION:
The correct Time and Date MUST be SET in order for the Medi-Link
GPRS/GSM Unit to function to its full potential and specifications. This can
be done either via the Red and Green Buttons or via the UpDownload
Programmer Software after exiting Program Mode.
Neatly tuck
wire in here.
