– 10 –
2. Point the remote control at your TV. Press and hold the TV and OK buttons for 3
seconds. The LED on the remote control will flash twice and the remote control will
switch to the setup mode. Release the TV and OK buttons.
3. Enter the four-digit setup code of your TV model from the table above. The LED will
flash each time you enter a digit.
4. If you entered the code correctly, the LED will blink twice. Otherwise – once.
5. Check the buttons operation. If most of the buttons function correctly, the code is
correct. If necessary buttons do not work properly, select another code from the
table and repeat steps 2–5.
Note: If no button is pressed or a non-numeric button is pressed for 20 seconds in setup
mode, the remote control switches to standby mode.
Controlling Volume of STB or TV
Remote can be configured to control the volume of the TV or STB. To switch between
these two states, press and hold the buttons POWER and V+ for three seconds. The LED
will blink twice and the remote will control the volume of the other device.
Changing STB Code
If using the remote control for STB results in any undesirable interference with your TV
(such as switching TV channels when you switch channels on STB), this means that the
codes used to control STB and TV overlap or are the same.
To eliminate this interference, change the code used by the remote control for STB. Since
there are two possible codes for STB, select the one that does not result in undesirable
interference with your TV.
To change the code, do the following steps:
1. Turn the STB on.
2. Press and hold POWER and OK buttons for three seconds. When the LED on
remote control lights up, release the buttons. The remote control will switch to the
setting mode. Release the TV and OK buttons.
3. By default, the STB uses the code 1256, you can change the code to 1255. Enter
the code 1255. The LED will flash each time you enter a digit.
4. If the code is entered correctly, the LED will flash twice. If the code is entered
incorrectly, the LED will flash once and the remote control will exit the setup mode.
Repeat steps 2–4.
5. Try pressing the remote control button that causes undesirable interference with
another device. If the conflict is resolved, the code has been selected correctly.
Resetting the Remote Control
To reset the remote control:
