60
61
English
User manual
smartgyro.es
1.
Remove the retaining pin from the seat post.
2.
Raise or lower the top seat post to the desired seat height.
3.
While holding the top seat post at that height, align the adjustment holes.
4.
Insert the retaining pin completely
VII. DISASSEMBLY AND ASSEMBLY OF SMARTGYRO AVANZA
DISASSEMBLY
You can disassemble the SmartGyro Avanza in four parts: seat, frame, basket and battery.
See Image 18.
Imagen 18. Avanza disassembled
No tools are required to disassemble or assemble your SmartGyro Avanza. Always disas-
semble or mount your SmartGyro Avanza on a level and dry surface, with enough space for
you to work and move.
Remember that some components of SmartGyro Avanza are heavy and you may need help
to lift them.
STEPS TO DISMOUNT YOUR SMARTGYRO AVANZA
1.
Remove the basket by lifting it up.
2.
Remove the battery compartment, pull up from its handle located on the top.
3.
Pull the seat lever to slap it.
4.
Fold the handlebar to its base, it has a thread that loosens the handlebar adjustment.
WARNING! Do not lift weight beyond your physical capacity. Ask for help
when it is necesario al desmontar o montar su SmartGyro Avanza.
VIII. BASIC PROBLEM SOLVING
Any electromechanical device occasionally requires some type of problem solving. Many of
these problems occur because the batteries are not fully charged or because the batteries
are worn out and can no longer hold a charge.
DIAGNOSTIC SOUNDS
The diagnostic sound codes for your SmartGyro Avanza are designed to help you perform
basic troubleshooting quickly and easily. A diagnostic beep will sound in case one of the
conditions listed below develops.
NOTE:
Your SmartGyro Avanza will not work unless the condition of the sound code is
resolved and the scooter has been restarted.
What happens if all the systems in my SmartGyro Avanza seem “disconnected”?
— Make sure the key is in the “on” position.
— Check that the batteries are fully charged.
— Press the reset button of the main switch. See III. “Your SmartGyro Advances.”
Check the fuse on the rudder scooter console located under the battery.
