HAT880 SERIES DUAL POWER BYPASS CONTROLLER USER MANUAL
HAT880 Series Dual Power Bypass Controller 2019-07-11 Version1.1 Page 17 of 49
8
START/STOP OPERATION
8.1
MANUAL START/STOP
8.1.1
PANEL START/STOP
In the main screen, press Set key to enter menu interface, and choose “Manual Test Genset” and
press Confirm key, manual start operation interface is entered.
Manual Test Genset
Press “Up/Down” key to choose parameters (the current line was
highlighted with black) and then press “Confirm” key to confirm.
0. Return
1. Genset Stop
2. Genset Start
Genset Stop
：
Disconnect the start signal, i.e. stop the running genset.
Genset Start
：
Output the start signal, i.e. start the genset.
When system is “S1 Gens S2 Gens S3 Mains”, manual start/stop menu interface is as follows:
Manual Test Genset
Press “Up/Down” key to choose parameters (the current line was
highlighted with black) and then press “Confirm” key to confirm.
0. Return
1. S1 Genset Stop
2. S1 Genset Start
3. S2 Genset Stop
4. S2 Genset Start
S1 Genset Stop
：
Disconnect the S1 start signal, i.e. stop the running S1 genset.
S1 Genset Start
：
Output the S1 start signal, i.e. start the S1 genset.
S2 Genset Stop
：
Disconnect the S2 start signal, i.e. stop the running S2 genset.
S2 Genset Start
：
Output the S2 start signal, i.e. start the S2 genset.
8.1.2
REMOTE START/STOP
Send remote start/stop signals using MODBUS protocol via RS485 port.
Remote Stop
：
Disconnect the start signal, i.e. stop the running genset.
Remote Start
：
Output the start signal, i.e. start the genset.
