6
2. Hardware istallation
2.1 System requirements
Before installing the SAG-1010, make sure that your system/network meets the following
requirements:
• An Ethernet RJ-45 port (10Base-T/100Base-TX)
• At least one IEEE 802.11b/g device with wireless capability
• An installed TCP/IP and Internet browser
2.2 Device installation
Follow these instructions to install the SAG-1010.
Connect the device to your computer, network hub, switch, or router.
2.2.1 Before you proceed
Take note of the following guidelines before installing the SAG-1010.
• The length of the Ethernet cable that connects the device to the network (hub, ADSL/cable
modem, router, wall patch) must not exceed 100 meters.
• Place the device on a flat, stable surface as far from the ground as possible.
• Keep the device clear from metal obstructions and away from direct sunlight.
• Keep the device away from transformers, heavy-duty motors, fluorescent lights, microwave
ovens, refrigerators, and other industrial equipment to prevent signal loss.
• Install the device in a central area to provide ideal coverage for all wireless mobile devices.
• Install the device at least 20cm from a person to insure that the product is operated in
accordance with the RF Guidelines for Human Exposure adopted by the Federal
Communications Commission.
