SMART PMCspan, Руководство пользователя

Страница: 25 / 64

Installing a PMCspan
PMCspan PMC Carrier Module Installation and Use (6806800A59C) 25
3. Slide the PMC module port connector into the PMC slot opening on the PMCspan front
panel.
4. Align the PMC module over the PMCspan.
– Align the connectors on the underside of the PMC module with the
corresponding connectors (J11, J12, and J14) on the PMCspan.
– Align the keying hole on the PMC module with the keying pin on the PMCspan.
5. Gently press the PMC onto the PMCspan.
– Turn the PMCspan component-side down.
6. Insert the four short Phillips screws supplied with the PMC module through the holes
on the underside of the PMCspan, into the standoffs at the corners of the PMC module
(note that some PMCs take a screw at each corner while others require only two screws
at the forward corners). Tighten the screws.
2.5 Installing a PMCspan
PMCspanX6E-002
The PMCspanx6E-002 mounts onto an MVME51005E or MVME55006E series processor
module. To upgrade or install a PMCspan, refer to the next figure and proceed as follows.
Figure 2-2 Typical PMC Module Placement on a VME Module