SMART FSSBID 100, Инструкция по установке и руководство интегратора, Страница: 41 / 104

1010651 Rev C1
3 1 | M O D E L F S S B I D 1 0 0 : C O N N E C T I N G D E V I C E S I N S I D E Y O U R S M A R T M O B I L E
S T A N D ’ S C A B I N E T
9. Route the other end of the camera cables back through the connection panel from
right to left, and then connect them to your SMART Board interactive display
frame’s controller box, coiling the excess cable and fastening it to the speaker
panel with cable ties, as shown below.
TIP
Leave some slack throughout the length of these cables. Don’t pull them tight.
Cable Connections to Your SMART Board Interactive Display Frame
Connect USB Cable C04
to the controller box,
creating a strain relief loop,
and then fasten it to a clip
on the speaker panel
with a plastic cable tie.
Coil and fasten the
excess camera cables
to the clips on the
speaker panel
with plastic cable ties.
Power Cable to
Your Controller Box
with Strain Relief Loop
Speaker Panel
Camera
Camera
Route camera cables up
your SMART Mobile Stand’s
prewired cable harness,
down behind the speaker
panel and along the inside
edge of the pencil ledge.