SMART FSSBID 100, Инструкция по установке и руководство интегратора, Страница: 39 / 104

1010651 Rev C1
2 9 | M O D E L F S S B I D 1 0 0 : C O N N E C T I N G D E V I C E S I N S I D E Y O U R S M A R T M O B I L E
S T A N D ’ S C A B I N E T
3. Connect your SMART Board interactive display frame’s power cable to your
interactive display frame’s power supply.
4. Connect the cable from your SMART Board interactive display frame’s
power supply to the controller box.
TIP
Route this cable up the cabinet’s rear support tube and behind the hydraulic
pump, leaving enough slack to create a strain relief loop.
5. Connect the other end to an available receptacle on your SMART Mobile Stand’s
power bar, and then coil and bundle any excess cable.
TIP
Place the power supply’s transformer box next to the power bar, on the floor
of your SMART Mobile Stand’s cabinet.
6. Remove the plastic cable tie from the USB B male cable (marked C04 )
in your prewired cable harness, and then connect this cable to the USB receptacle
on your interactive display frame’s controller box.
NOTE
The other end of cable C04 is prewired to your SMART Mobile Stand’s
connection panel (which connects to your computer or SMART Hub).
TIP
– Leave enough slack in this cable to create a strain relief loop.
– Use a plastic cable tie to fasten this cable to the clip on the inside
of your SMART Mobile Stand’s speaker panel, as illustrated on page 31.
USB B Cable C04