Smart system SmartCam Zen, Краткое руководство пользователя

Страница: 27 / 29

8.4.1.2 Zen Upside Down
It allows you to completely rotate SmartCAM Zen by 180 ° so that the LED display is facing
downwards.
This is very convenient for bringing the LED display as close as possible to the third-party
LCD monitor.
8.4.1.3 Fast Menu Exit
By enabling this option, you can change the Long Click behavior of the menu button from
"
RETURN " to " MENU EXIT ".
8.4.2 Zen Mode
It is possible to set the ZEN in two specific operating modes that characterize its behavior:
STANDARD and DYNAMIC
8.4.2.1 Standard Mode
In this operating mode, the sensors inside ZEN are calibrated in such a way as to provide
maximum stability over time as regards the detection of rotations inherent in ROLL, TILT,
PAN and STS.
This mode is recommended for use on static vehicles where ZEN is rarely subjected to
continuous movements
8.4.2.2 Dynamic Mode
In this operating mode, the sensors inside ZEN are calibrated in such a way as to provide
maximum accuracy in detecting rotations inherent in ROLL, TILT and STS.
This mode is recommended for use on mobile vehicles where ZEN is continuously
subjected to movements.
8.4.3 Menu Timeout
In this menu it is possible to modifiy the time that keep the menu open since last operation.
The possible values are: 5sec, 10sec, 20sec, Never
When “never” is selected, the menu is kept open until manual exit.
8.4.4 Firmware
In this menu, you can check the current firmware version installed in your ZEN.
If necessary, it is possible to reset the ZEN to the factory settings thanks to the "FACTORY
RESET" menu
By executing a “FACTORY RESET” the system will be reset itself with
all the default parameters
27