Smart Start SSI 20/20, Руководство пользователя

Страница: 17 / 34

SSI-20/20 - 20/30 Headset LCD Messages
LCD DISPLAY DESCRIPTION
INITIALISING The unit is initialising
WAIT###
The unit is preparing for a breath test
BLOW The unit is ready to accept a breath test
ANALYSING The unit is analysing the breath sample
PASS
Test is successful
HUM STRONGER Hum was not performed properly. SSI-20/20 only
BLOW HARDER Stopped preforming test sequence before sample was
taken or not sufficient breath pressure
BLOW SOFTER
Blowing too hard
DONT INHALE Negative pressure was detected
MOUTH CLOSER Mouth not close enough to sensor
ABORT TAMPER
Blockage in the breath pathway detected. This may be
caused by your hands covering the back vent
PLEASE RETRY Fuel cell did remain stable before sample taken
ABORT PUMP Pump failed to pull sample and may have a fault. Please
contact head office
ABORT LOCK Locked: Abort count exceeded
RESTART ##:##
Engine can be started within the specified time
BLOW ##:## unit requires a retest within the stated amount of time
MISSED RETEST Retest missed
APPT ## / ## Appointment time is on ## days and ## hrs. to see this
press the hash(#) key and then number 1
VIOL REMAIN ## The number of violations remaining before the unit goes
into the grace period before lockout. To see this press the
hash(#) key and then the number 3
V LOCK #D : #
A reminder of the hours remaining until lockout due to
violations
16