Installation of the Receiver
7
If the device is transported from
cold to hot environment, then
condensing humidity may build
up in the device.
Do not connect the device, but
leave it switched-off for some
hours.
3.4
Handling of Batteries
•
Batteries should always be out of chil-
dren's reach.
•
Leaking batteries cause damage to the
environment and the remote control.
•
Batteries should not be exposed to ex-
treme heat, e.g. sunlight, fire etc.
Dispose of the batteries in accordance with
the applicable legal regulations (see chap-
ter Disposal, page 21).
3.5
Notes on Product Liability
In the following cases, the intended protection
of the device may be limited. Then, liability
regarding function of the device correspond-
ingly passes over to the operator:
•
The device is not used in accordance with
the user manual.
•
The device is used out of the field of appli-
cation as described above.
•
The operator performs unauthorized
changes of the device.
4
Installation of the Receiver
CAUTION!
First connect the receiver
to the cable connection
and any other devices be-
fore connecting the mains
plug to the power outlet.
Please also note the user
manuals of the other de-
vices.
4.1
Connection Scheme
default connection
optional connection
4.2
Connect TV Cable
Connect the TV cable to the receiver con-
nection
ANT IN
.
Further receivers can be connected at the
connection
ANT
OUT
. The signal is looped
through from input
ANT
IN
.
If your receiver is in sleep mode
(deep standby) or the device was
disconnected from power (via pow-
er switch or by pulling the plug),
there is no or just a weakened signal
at
ANT OUT
.
4.3
Connect TV Set
Connect TV set and receiver by using a
SCART cable.
4.4
Connect Home Cinema System
To improve audio playback, you can connect
to the receiver - additionally to the TV set - also
a multichannel home cinema system or a hi-fi
system. There are various possibilities for
connection. Your type of connection depends
on the connection possibilities of your home
cinema system.
Connect the home cinema system and the
receiver (
DIGITAL AUDIO
) by using an
RCA cable.
