Fig. A
Fig. B
Installation and Operation
-
7-
5. Configuring the Video Processing.
On the base of the unit are four switches, these are to be used to configure
the way in which the unit handles video sources. The switches functionality are
as follows:
5.1
If more than 16 units are used then the Hex Switch (see following
page) is unable to address them. To enable the addressing of units
as 17-32 then switch 1 on their base should be placed to the ON
position.
5.2.
Switch 2 is used to enable and disable the auto-detect feature of the
units.
Switches 3 & 4 are used to determine the source priority when the auto-
detect feature is in use.
5.3
Switch 3 is used to set priority to RGB 1
5.4
Switch 4 is used to set priority to Y/C or RGB 2
5.5
If both switches 3 & 4 are set to ON - priority will be given to CVBS.
Fig. A Shows all
switches in the OFF
position,
Fig. B shows switch
1 in the ON position,
switches 2-4 in the
OFF position.
